Print Preview for Lazarus?

Please post bug reports, feature requests, or any question regarding the DELPHI AREA products here.

Print Preview for Lazarus?

Postby Dibo » July 17th, 2005, 1:43 pm

Is it possible? Please answer in beginner english because i'm from poland :)
Dibo
Member
Member
 
Posts: 1
Joined: July 17th, 2005, 1:31 pm

Postby Johnny_Bit » August 5th, 2005, 7:21 pm

Is Lazaruss in pre-release state?

Altrough it's preety good on FreePascal, personally I think, that until good delphi support in it is done, there's no sense of re-making the whole thing (that or wait until IDE is mature).

//ps. Don't you have English lessons in your school? I'm from Poland too, but does that mean I don't use foreign languages. It's bad excuse, 'cause many people in this forum aren't native english-speakers.
Johnny_Bit
VIP Member
VIP Member
 
Posts: 455
Joined: June 15th, 2003, 9:56 am

Postby Radagast » August 11th, 2005, 8:53 pm

Lazarus isn't version 1 yet I think. Have anyone tried it thoroughly? I installed Polish (yup! I'm from Poland too) version and it was VERY BAD. I mean you couldn't read anything with Polish fonts. But I think I should try installing English version (I haven't seen Polish Delphi and I don't want to) and check it. I've seen some useful tools that are not present in Delphi Personal.
And I have question to this topic: Has anyone tried to do this or you prefer to think it's impossible?
Radagast
Active Member
Active Member
 
Posts: 24
Joined: May 1st, 2005, 9:32 pm
Location: Poland

Postby Johnny_Bit » August 13th, 2005, 7:53 am

Nothing is impossible. It's barelly few thousands lines of code.

ps. In asembler everything is possible
Johnny_Bit
VIP Member
VIP Member
 
Posts: 455
Joined: June 15th, 2003, 9:56 am


Return to DELPHI AREA Products

Who is online

Users browsing this forum: No registered users and 1 guest