Hi
With the 5.10 version
the problem is reduced but
always present, if you try
to draw these three rectangles
Rectangle(20,20,30,30);
Rectangle(30,20,40,30);
Rectangle(20,31,30,41);
you will notice that the common side of the first two
rectangles (at the 30 position), appear more marked than
right side of the third rectangle (at the 30 position)
all sides that the rectangles have in common seem designed more marked
in my invoice report is not good
I wish that all the lines of the rectangles
had the same thickness
Thanks again for your interest